Suggested surfaces :
Cement, concrete, slate
Bricks, tiles, pottery
Natural and unnatural stones are not absorbed and polished
General instructions :
One liter covers 5 to 15 square meters with one layer.
Remove any dirt and dust from the surface.
If there are ; Thoroughly clean the surface of oil, rust, mold or moss.
Repair cracks and loose parts on the surface.
Do not use the product on pre-coated surfaces.
Allow the wet surface to dry completely before using the product
This product is ready to use and does not need to be diluted.
Stir the product thoroughly before use and check that it is homogeneous.
Use the product in 2 layers with a brush, roller or spray. Apply the second layer before the first layer dries (wet on wet).
Wait 24 hours for it to dry.
If it rains during use, cover the applied surface and keep it closed until completely dry.
For external and internal use.
If not in use, keep the product closed.
The general application temperature of the product is between 15 to 25 degrees Celsius and 40 to 65 percent in relative humidity.
Do not use the product in direct sunlight or rain.
The product must be protected from freezing and stored at a temperature between 5 and 35 ° C.
Painting tools should be cleaned after use with soap and plenty of warm water.
Security considerations :
Use with proper ventilation.
Keep out of reach of children.
Do not transfer contents to other containers for storage.
Do not use empty plastic cans for other purposes.
Open windows and doors to prevent overexposure, or use other means to ensure fresh air enters during use and drying.
Avoid contact with eyes and skin.
Wash hands after use.
First aid: In case of contact with eyes, rinse immediately with plenty of water. See your doctor if irritation persists. If swallowed, contact poison control center, hospital emergency department or physician immediately.
Dispose of plastic contents / cans in accordance with national regulations.
Please refer to the Product Safety Data Sheet (SDS) for safety and health information.